Dell Force10 S25-01-GE-24P Manual - Halaman 10
Jelajahi secara online atau unduh pdf Manual untuk Server Dell Force10 S25-01-GE-24P. Dell Force10 S25-01-GE-24P 48 halaman. Installing the s25p system
Juga untuk Dell Force10 S25-01-GE-24P: Panduan Konfigurasi (8 halaman)
Halaman Cetak
Equipment
The following items are necessary to install the S25P system:
•
The switch
•
At least one grounded AC power source per S25P
•
One AC cable is included to connect the AC power source to the S25P
(power cables are not supplied for the S25P-DC)
•
Bracket ears for rack installation (supplied)
•
Screws for rack installation (supplied) and #2 Phillips screwdriver (not supplied)
Other optional components are:
•
Stacking cables for connecting S-Series switches in a stack
•
Optical networking components (see
•
Stacking components (see Ports, below)
Features
•
S25P CPU and switch processor
•
32MB internal Flash memory
•
256MB RAM
•
Stackable switch features
•
19-inch rack-mountable
•
Standard 1U chassis height
•
Six built-in fans
•
Two internal AC power supplies acting in load-sharing mode
•
Up to 16384 MAC address entries supported with hardware-assisted aging
•
Supports 9252-byte jumbo frames in FTOS, 9216-byte jumbo frames in SFTOS
•
Back-pressure support at half-duplex, IEEE 802.3x flow control at full duplex
•
Extensive LED system with per-port LEDs
Ports
•
24 SFP ports capable of using 100/1000 Base-T or 1000 Base-X using auto-media detect
•
Four shared RJ45 10/100/1000 Base-T ports
•
Console port (see
(straight-through Ethernet copper cable) and terminal adapter (DB-9 to RJ-45)
•
Two expansion slots that accept any combination of the following optional, high-capacity uplink
modules:
— 10GbE XFP (two ports)
— 10GbE CX4 (two ports)
— 12G Stacking (two ports)
— 24G Stacking (one port)
See
Inserting Optional Modules (10-Gigabit or Stacking) on page 17
(optional) on page
10
Chapter 4, Installing Ports, on page
Accessing the Console Port on page
25.
29)
29): Supplied with console cable
and
Connecting Stack Ports
S25P System Overview