Dell PowerEdge 4x00 Series Panduan Instalasi - Halaman 22
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell PowerEdge 4x00 Series. Dell PowerEdge 4x00 Series 28 halaman. Rack installation guide
Juga untuk Dell PowerEdge 4x00 Series: Pemasangan Rak (37 halaman), Panduan Pengguna (42 halaman), Pemasangan Rak (34 halaman), Panduan Instalasi (37 halaman)
Halaman Cetak
1-16
Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
3.
Reinstall the front-panel inserts to match the new drive orientation.
4.
Slide the system board tray out to the service position.
See " Accessing the Interior of Your Computer" in your system's Installation and
Troubleshooting Guide for instructions.
5.
Remove the drives from the drive bays:
a.
Disconnect the DC power cable and the interface cable from the back of the
drive. Be sure to record the power connector number and the location of the
interface connector.
b.
Press inward (toward the center of drive) on the two drive release tabs, and
slide the drive out of the bay.
c.
If any of the drive bays are empty, remove the metal insert(s) covering the
bay(s) and reinsert them in the proper orientation.
6.
Reinstall the external drives to match the new system orientation:
a.
Slide each drive into the bay until it snaps securely into place.
b.
Reconnect the appropriate DC power cable and interface cable to each drive.
7 .
Close the system board tray.
Reorienting the System Badge
To rotate the system badge on the front bezel, perform these steps:
1.
Facing the inner side of the bezel, remove the system badge by compressing the
tabs extending through the slots in the bezel, and push the badge out of its
frame.
2.
Rotate the badge 90 degrees to match the new orientation of the system.
3.
Facing the outer side of the bezel, install the new system badge by inserting the
tabs through the slots in the face of the bezel until the tabs snap into place.
Replacing the Front Bezel
To replace the front bezel of the system, perform these steps:
1.
Align the three clips on the edge of the bezel and press the bezel into place until
the tabs on the opposite edge of the bezel snap into place.
2.
Reinstall the system cover.