Dell PowerEdge 650 Manual Petunjuk Penggantian - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Penggantian untuk Server Dell PowerEdge 650. Dell PowerEdge 650 16 halaman. Replacing the system and backplane board assemblies

Halaman Cetak
17
Loosen the two thumbscrews securing the riser board and disconnect it from the system
board card-edge connector. See "Removing the Riser Board" in your Installation and
Troubleshooting Guide.
18
Slide the backplane securing latch forward to the open position to allow the system
board/backplane board to move to the forward (unlatched) position.
19
Slide the system board/backplane board assembly forward, toward the front of the system and
lift the assembly up and out of the chassis. See Figure 1-1.
Figure 1-1. Removing the System Board/Backplane Board Assembly
backplane release latches (2)
20
Lay the system board/backplane board assembly down on a smooth, nonconductive work
surface.
21
Remove the three Phillip screws that secure the system board to the backplane board. See
Figure 1-2.
4
Replacing the System and Backplane Board Assemblies
thumbscrew
backplane securing latch