Dell PowerEdge 650 Instrukcja wymiany - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Serwer Dell PowerEdge 650. Dell PowerEdge 650 16 stron. Replacing the system and backplane board assemblies
Drukuj stronę17
Loosen the two thumbscrews securing the riser board and disconnect it from the system
board card-edge connector. See "Removing the Riser Board" in your Installation and
Troubleshooting Guide.
18
Slide the backplane securing latch forward to the open position to allow the system
board/backplane board to move to the forward (unlatched) position.
19
Slide the system board/backplane board assembly forward, toward the front of the system and
lift the assembly up and out of the chassis. See Figure 1-1.
Figure 1-1. Removing the System Board/Backplane Board Assembly
backplane release latches (2)
20
Lay the system board/backplane board assembly down on a smooth, nonconductive work
surface.
21
Remove the three Phillip screws that secure the system board to the backplane board. See
Figure 1-2.
4
Replacing the System and Backplane Board Assemblies
thumbscrew
backplane securing latch