Dell PowerEdge 860 Panduan Servis - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Servis untuk Server Dell PowerEdge 860. Dell PowerEdge 860 37 halaman. Sas/raid controller installation
Juga untuk Dell PowerEdge 860: Pembaruan Informasi (14 halaman), Instal Manual (28 halaman), Panduan Petunjuk Instalasi (7 halaman)
Back to Contents Page
Battery Latch Assembly
Dell™ Vostro™ A840/A860 Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back
panel of the computer.
Removing the Battery Latch Assembly
1. Follow the instructions in
Before You
1. Remove the system board (see
2. Remove the screw from the battery-lock latch and remove it.
3. Remove the screw from the battery-bay release latch.
NOTICE:
Before you remove the battery release button, observe the orientation of the button to ensure proper installation when the button is
replaced.
4. Slide the battery latch assembly to the right to remove it.
5. Unhook the latch spring from the latch.
1
battery-lock latch
3
latch spring
Replacing the Battery Latch Assembly
NOTICE:
Ensure the battery latch assembly is properly oriented. The indent for the button should face up when installing the assembly.
1. Replace the spring and slide the battery latch assembly into place.
2. Replace and tighten the screws.
3. Replace the system board (see
4. Slide the battery into the battery bay, until it clicks in place.
Begin.
System
Board).
2
battery-bay release latch
Replacing the System
Board).