Dell PowerEdge R620 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Server Dell PowerEdge R620. Dell PowerEdge R620 11 halaman. Poweredge series
Juga untuk Dell PowerEdge R620: Panduan Memulai (12 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Panduan Portofolio (27 halaman), Panduan Memulai (10 halaman), Panduan Pemasangan, Pemeliharaan, dan Pemecahan Masalah (48 halaman)

Cable Routing Procedures for Dell PowerEdge R620 Systems

Section 2: Replacing a power supply on a PowerEdge R620

system with a CMA

1. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

2. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

3. Disengage the strain relief and disconnect the power cord from the power supply.

4. Replace the power supply.

5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.

1. If the innermost power supply must be replaced, then follow the steps described in Section 2.1. If

the outermost power supply must be replaced, follow the steps described below.

2. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

3. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

4. Disengage the strain relief and disconnect the power cord from the power supply.

5. Disconnect both CMA attachment housings from the brackets on the rails as shown in Figure 7.

6. Detach the inner CMA bracket from the rail by pushing on the end of the lock spring and lifting the

bracket up and to the left until it clears the standoffs on the rail.

7. While supporting the CMA with one hand, remove and replace the outer power supply with the

other hand as shown in Figure 8.

8. Reinstall the inner CMA bracket to the rail and reconnect the CMA to the brackets.

9. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.