Dell PowerEdge R620 매뉴얼 - 페이지 8

{카테고리_이름} Dell PowerEdge R620에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge R620 11 페이지. Poweredge series
Dell PowerEdge R620에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (12 페이지), 설치 지침 (2 페이지), 설치 지침 (2 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (10 페이지), 설치, 유지 관리 및 문제 해결 매뉴얼 (48 페이지)

Cable Routing Procedures for Dell PowerEdge R620 Systems

Section 2: Replacing a power supply on a PowerEdge R620

system with a CMA

1. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

2. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

3. Disengage the strain relief and disconnect the power cord from the power supply.

4. Replace the power supply.

5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.

1. If the innermost power supply must be replaced, then follow the steps described in Section 2.1. If

the outermost power supply must be replaced, follow the steps described below.

2. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

3. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

4. Disengage the strain relief and disconnect the power cord from the power supply.

5. Disconnect both CMA attachment housings from the brackets on the rails as shown in Figure 7.

6. Detach the inner CMA bracket from the rail by pushing on the end of the lock spring and lifting the

bracket up and to the left until it clears the standoffs on the rail.

7. While supporting the CMA with one hand, remove and replace the outer power supply with the

other hand as shown in Figure 8.

8. Reinstall the inner CMA bracket to the rail and reconnect the CMA to the brackets.

9. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.