Dell PowerEdge R620 매뉴얼 - 페이지 10

{카테고리_이름} Dell PowerEdge R620에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge R620 11 페이지. Poweredge series
Dell PowerEdge R620에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (12 페이지), 설치 지침 (2 페이지), 설치 지침 (2 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (10 페이지), 설치, 유지 관리 및 문제 해결 매뉴얼 (48 페이지)

Cable Routing Procedures for Dell PowerEdge R620 Systems

Section 3: Cabling a PowerEdge R620 system on sliding rails

without a CMA

NOTE: The CMA for Dell PowerEdge R620 is optional. Without the CMA installed, the system must be

powered down and all cables disconnected before it can be extended out of the rack.

1. Connect all applicable cables to the rear of the system and verify that all connections are secure.

2. Using the hook-and-loop straps supplied with the rail kit, bundle the cables and secure them to

either the left or right outer CMA attachment bracket as described in the Rack Installation

Instructions. See Figure 9 for an example of data cables secured to the left outer CMA bracket and

power cables secured to the right outer CMA bracket (as viewed from the rear of the system).

If you are installing the system into a shallow rack (less than 1 meter deep) and you will not be

installing a CMA, the outer CMA brackets may be removed from the sliding rails if necessary in order to

allow the rails to fit properly into the rack. Remove the brackets by using a #2 Phillips screwdriver to

remove the screws that secure the brackets to the rails as shown in Figure 10. Use the hook-and-loop

straps supplied with the rail kit to secure the cables to the rack frame if desired.

Figure 10.

Figure 9.

Cable routing without a CMA

Removing the outer CMA brackets for shallow racks