Dell PowerVault MD3200 Series Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell PowerVault MD3200 Series. Dell PowerVault MD3200 Series 18 halaman. Storage arrays
Juga untuk Dell PowerVault MD3200 Series: Manual Pembaruan (32 halaman), Petunjuk Pemasangan Rak (2 halaman), Matriks Dukungan (12 halaman), Panduan Penyebaran (38 halaman), Pembaruan Informasi (1 halaman), Matriks Dukungan (17 halaman), Buku Panduan Teknis (40 halaman), Buku Putih (22 halaman), Panduan Penyebaran (38 halaman), Panduan Penyebaran (38 halaman)

Managing SMI-S Provider

Starting and Stopping the OpenPegasus CIM

Server

To start or stop the OpenPegasus CIM server:

Open the Services window and locate the cimserver service. Right-click

•

cimserver service and select start or stop.

•

In the command prompt:

To start the service, type: net start cimserver

To stop the service, type: net stop cimserver

To start or stop the OpenPegasus CIM server, on a terminal window:

To start the service, type: cimserver

To stop the service, type: cimserver -s

Adding or Removing a Storage Array From SMI-S

Provider

At installation, you are prompted to enter the IP addresses into a file. After

this initial setup, the SMI-enabled client must use the SMI-S Provider proxy

server system management profile to add or remove devices.

NOTE:

When a storage array is added, an IP address of only one of the

management ports of the storage array must be supplied (and not both

management ports). Entering the IP addresses for both management ports of a

single storage array causes unpredictable behavior of the SMI-S Provider.

Managing SMI-S Provider