Dell PowerVault MD3200 Series 설치 매뉴얼 - 페이지 13

{카테고리_이름} Dell PowerVault MD3200 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3200 Series 18 페이지. Storage arrays
Dell PowerVault MD3200 Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 지원 매트릭스 (12 페이지), 배포 매뉴얼 (38 페이지), 정보 업데이트 (1 페이지), 지원 매트릭스 (17 페이지), 기술 매뉴얼북 (40 페이지), 백서 (22 페이지), 배포 매뉴얼 (38 페이지), 배포 매뉴얼 (38 페이지)

Managing SMI-S Provider

Starting and Stopping the OpenPegasus CIM

Server

To start or stop the OpenPegasus CIM server:

Open the Services window and locate the cimserver service. Right-click

•

cimserver service and select start or stop.

•

In the command prompt:

To start the service, type: net start cimserver

To stop the service, type: net stop cimserver

To start or stop the OpenPegasus CIM server, on a terminal window:

To start the service, type: cimserver

To stop the service, type: cimserver -s

Adding or Removing a Storage Array From SMI-S

Provider

At installation, you are prompted to enter the IP addresses into a file. After

this initial setup, the SMI-enabled client must use the SMI-S Provider proxy

server system management profile to add or remove devices.

NOTE:

When a storage array is added, an IP address of only one of the

management ports of the storage array must be supplied (and not both

management ports). Entering the IP addresses for both management ports of a

single storage array causes unpredictable behavior of the SMI-S Provider.

Managing SMI-S Provider