Dell PowerVault MD3600f Series Panduan Penyebaran - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Penyimpanan Dell PowerVault MD3600f Series. Dell PowerVault MD3600f Series 36 halaman. Remote replication
Juga untuk Dell PowerVault MD3600f Series: Panduan Konfigurasi (22 halaman), Panduan Instalasi (18 halaman), Matriks Dukungan (17 halaman), Panduan Fungsional (15 halaman)
Halaman Cetak
Post Installation Tasks
Before using the PowerVault MD3600f Series storage array for the first time,
complete a number of initial configuration tasks in the order shown. These
tasks are performed using the MD Storage Manager (MDSM) software.
1 For out-of-band management, you must set the network configuration for
each RAID controller module, including its Internet Protocol (IP) address,
subnetwork mask (subnet mask), and gateway.
NOTE:
You can set the network configuration using a DHCP server.
2 Start MDSM.
•
On Microsoft Windows operating systems, click StartPrograms
DellMD Storage ManagerModular Disk Storage Manager
Client.
On Linux operating systems, click the MD Storage Manager desktop
•
icon. You can also launch MD Storage Manager in Linux by running
the following commands at the command prompt:
cd
/opt/dell/mdstoragesoftware/mdstoragemanager/c
lient
./SMclient
3 In the Enterprise Management Window (EMW), go to Setup Add
Storage Array and start the automatic discovery of systems.
NOTE:
Only storage arrays configured with IP address on the same subnet as
the management stations will be detected.
NOTE:
It may take several minutes for the discovery process to complete.
Closing the Automatic Discovery Status window before this stops the
discovery process.
After discovery is complete, a confirmation screen appears.
Post Installation Tasks
4
21