Dell PowerVault MD3600f Series 배포 매뉴얼 - 페이지 21

{카테고리_이름} Dell PowerVault MD3600f Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3600f Series 36 페이지. Remote replication
Dell PowerVault MD3600f Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (22 페이지), 설치 매뉴얼 (18 페이지), 지원 매트릭스 (17 페이지), 기능 매뉴얼 (15 페이지)

페이지 인쇄
Dell PowerVault MD3600f Series 배포 매뉴얼

Post Installation Tasks

Before using the PowerVault MD3600f Series storage array for the first time,
complete a number of initial configuration tasks in the order shown. These
tasks are performed using the MD Storage Manager (MDSM) software.
1 For out-of-band management, you must set the network configuration for
each RAID controller module, including its Internet Protocol (IP) address,
subnetwork mask (subnet mask), and gateway.
NOTE:
You can set the network configuration using a DHCP server.
2 Start MDSM.
•
On Microsoft Windows operating systems, click StartPrograms
DellMD Storage ManagerModular Disk Storage Manager
Client.
On Linux operating systems, click the MD Storage Manager desktop
•
icon. You can also launch MD Storage Manager in Linux by running
the following commands at the command prompt:
cd
/opt/dell/mdstoragesoftware/mdstoragemanager/c
lient
./SMclient
3 In the Enterprise Management Window (EMW), go to Setup Add
Storage Array and start the automatic discovery of systems.
NOTE:
Only storage arrays configured with IP address on the same subnet as
the management stations will be detected.
NOTE:
It may take several minutes for the discovery process to complete.
Closing the Automatic Discovery Status window before this stops the
discovery process.
After discovery is complete, a confirmation screen appears.
Post Installation Tasks
4
21