Dell PowerVault MD3600f Series 배포 매뉴얼 - 페이지 22
{카테고리_이름} Dell PowerVault MD3600f Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3600f Series 36 페이지. Remote replication
Dell PowerVault MD3600f Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (22 페이지), 설치 매뉴얼 (18 페이지), 지원 매트릭스 (17 페이지), 기능 매뉴얼 (15 페이지)
페이지 인쇄
Verifying Storage Array Discovery
The Automatic Discovery option automatically discovers both in-band and out-
of-band arrays and adds the storage arrays to the management domain. If the out-
of-band or in-band connections shown on the summary page are not accurate,
complete the following steps. For more information, see the online help.
1 Check the hardware and connections for possible problems. For specific
procedures on troubleshooting interface problems, see the Owner's Manual
at support.dell.com/manuals.
2 Verify that the array is on the local subnetwork. If it is not, click the new
link to manually add it.
3 Verify that the status of each storage array is Optimal. If any array shows
an Unresponsive status, complete one of the following steps:
To remove the array from the management domain, highlight the
a
array and then click Remove link.
To add an array, click New link.
b
In Linux, click the Manual button and click OK.
4 If the array still shows an Unresponsive status, contact Dell.
Initial Setup Tasks
1 The name of the first storage array found appears in the Devices tab of the
EMW. To see a list of all storage arrays found on the local network, expand
the discovered storage arrays tab in the device pane of the EMW.
2 The default name for a newly installed MD3600f series storage array is
Unnamed. If another name appears in MDSM, click the down arrow next
to the name and click Unnamed in the drop-down list.
3 Double-click on the discovered array to launch the array management
window and make changes to the configuration of the array.
4 Click Perform Initial Setup Tasks to see an outline and links to the
remaining post-installation tasks. The array is now ready to be configured.
See the Owner's Manual for information about each task and to perform
the necessary configuration steps. Table 4-1 lists the recommended
configuration steps that can be accomplished using the Owner's Manual.
22
Post Installation Tasks