Dell Force 10 Manual - Halaman 20

Jelajahi secara online atau unduh pdf Manual untuk Beralih Dell Force 10. Dell Force 10 29 halaman. Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

Figure 16.

3. Click OK and then Quit to return to the command prompt. The FCoE client should now start as

part of SLES 11 SP2s boot process, and the FCoE LUNs should be available after the system

boots.

Troubleshooting

Various conditions may exist on the network that interferes with FIPS snooping, particularly on

congested networks.

If the FCoE client is unable to see the FCoE VLAN after booting, restart the lldpad and fcoe

daemons as a troubleshooting step.

1. To restart the lldpad and fcoe daemons, run the following commands:

rcfcoe stop; rclldpad stop; rclldpad start; rcfcoe start

2. Then check the FCoE VLAN status by running fcoeadm -i . Figure 17 shows VLAN status

details.

Configure FCoE to start at system boot.