Dell Force10 S4820T System Panduan Memulai - Halaman 32
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Beralih Dell Force10 S4820T System. Dell Force10 S4820T System 39 halaman.
Halaman Cetak
To set up the RS-232/RJ-45 console port, follow these steps:
Step
Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to
1
connect the S4820T console port to a terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Set the default terminal settings as follows:
3
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
Accessing the RJ-45 Console Port with a DB-9 Adapter
If the DTE has a DB-9 interface, you can connect to the console using an RJ-45
to DB-9 adapter along with the RJ-45 rollover cable. Table 2-1 lists the pin
assignments.
Table 2-1. Pin Assignments Between the Console and a DTE Terminal Server
Console Port
RJ-45 to RJ-45 Rollover Cable
Signal
RJ-45 Pinout
RTS
1
NC
2
TxD
3
GND
4
GND
5
RxD
6
NC
7
CTS
8
26
Performing the Initial Configuration
RJ-45 to DB-9
Adapter
RJ-45 Pinout
DB-9 Pin
8
8
7
6
6
2
5
5
4
5
3
3
2
4
1
7
Terminal Server
Device
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS