Dell Force10 S60 Series Manual - Halaman 20

Jelajahi secara online atau unduh pdf Manual untuk Beralih Dell Force10 S60 Series. Dell Force10 S60 Series 45 halaman.
Juga untuk Dell Force10 S60 Series: Panduan Memulai Cepat (29 halaman)

Halaman Cetak
Dell Force10 S60 Series Manual
The PWR Light Emitting Diode (LED) blinks until the boot-up sequence is complete. When the boot up
is complete, the PWD LED is steadily lit.
The Stack ID LED displays a digit to show the position of the unit in a stacking chain. For a single
chassis, a 0 displays.

AC Power

Connect the plug to each AC receptacle
As soon as the cable is connected between the S60 system and the power source, the system is
powered-up; there is no on/off switch.
Figure 3-7. AC Power Connection

DC Power

To connect DC power
Step
Task
Remove the small plastic cover from the DC connectors.
1
Attach the connectors to both the DC PSUs at the rear of the S60 system. Ensure the connection is secure.
2
Replace the plastic cover over the DC connectors.
3
Turn the power switch on.
4
Figure 3-8. DC power connection
(Figure
(Figure
3-8), follow these steps:
3-7). Ensure the power cord is secure.
Install the S60 System
|
20