Dell Networking 8100 Series Panduan Konfigurasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Dell Networking 8100 Series. Dell Networking 8100 Series 17 halaman. Expansion modules for dell networking switches
Juga untuk Dell Networking 8100 Series: Mulai di sini (2 halaman), Mulai di sini (2 halaman), Setup Manual (2 halaman), Panduan Referensi (17 halaman)
Halaman Cetak
console(config)#exit
2.7
Enable iSCSI optimization feature
This feature, enabled by default, is activated when EqualLogic arrays are detected. It automatically
performs the following:
Configures jumbo frames to 9216 on all ports.
Disables unicast storm.
Enables spanning tree portfast on ports connected to EqualLogic arrays.
Configures flow control on all ports.
Note: Spanning tree portfast must be manually configured for host facing ports. Refer to Section 2.8.
console#configure
console(config)#iscsi enable
Enabling iSCSI Optimization will enable Flow Control which may cause all the
interfaces to temporarily go down.
Are you sure you want to continue? (y/n) y
console(config)#exit
2.8
Configure flow control (optional)
Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon
detection of an EqualLogic Array. If you plan to enable DCB (using Section 3), you may skip this section.
console#configure
console(config)#flowcontrol receive on
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
console(config)#exit
2.9
Configure Jumbo MTU for all ports
console(config)#system jumbo mtu 9216
console(config)# exit
10
SCG1001
Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide