- ページ 10

スイッチ Dell Networking 8100 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell Networking 8100 Series 17 ページ。 Expansion modules for dell networking switches
Dell Networking 8100 Series にも：ここからスタート (2 ページ), ここからスタート (2 ページ), セットアップマニュアル (2 ページ), リファレンス・マニュアル (17 ページ)

console(config)#exit

2.7

Enable iSCSI optimization feature

This feature, enabled by default, is activated when EqualLogic arrays are detected. It automatically

performs the following:

 Configures jumbo frames to 9216 on all ports.

 Disables unicast storm.

 Enables spanning tree portfast on ports connected to EqualLogic arrays.

 Configures flow control on all ports.

Note: Spanning tree portfast must be manually configured for host facing ports. Refer to Section 2.8.

console#configure

console(config)#iscsi enable

Enabling iSCSI Optimization will enable Flow Control which may cause all the

interfaces to temporarily go down.

Are you sure you want to continue? (y/n) y

console(config)#exit

2.8

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon

detection of an EqualLogic Array. If you plan to enable DCB (using Section 3), you may skip this section.

console#configure

console(config)#flowcontrol receive on

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to continue? (y/n)y

console(config)#exit

2.9

console(config)#system jumbo mtu 9216

console(config)# exit

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide