Dell PowerConnect B-RX4 Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Dell PowerConnect B-RX4. Dell PowerConnect B-RX4 17 halaman. Instant access point
Juga untuk Dell PowerConnect B-RX4: Manual (10 halaman)
Halaman Cetak5. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-degree
angle to the ceiling tile rail (see
6. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into place on the ceiling tile rail.
Figure 4
7. On the W-AP134, install the external antennas according to the manufacturer's instructions, and connect the
antennas to the antenna interfaces on the AP.
Connecting Required Cables
Install cables in accordance with all applicable local and national regulations and practices.
Ethernet Ports
The RJ-45 Ethernet ports (ENET0 and ENET1) support 10/100/1000Base-T auto-sensing MDI/MDX
connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to an Dell
PowerConnect Controller. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet) long.
The 10/100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female connectors
with the pin-outs shown in .
Table 1
Connector
Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide
Mounting the AP
Ethernet Port Pin-out
Signal
Pin
Name
1
BI_DA+
2
BI_DA–
3
BI_DB+
4
BI_DC+
5
BI_DC–
6
BI_DB–
7
BI_DD+
8
BI_DB–
Figure
4). Make sure that any cable slack is above the ceiling tile.
GE Connection
Bi-directional pair A+
Bi-directional pair A–
Bi-directional pair B+
Bi-directional pair C+
Bi-directional pair C–
Bi-directional pair B–
Bi-directional pair D+
Bi-directional pair D–
FE
PoE
Connection
RX+
POE negative
RX–
POE negative
TX+
POE positive
Spare pair
POE positive
Spare pair
POE positive
TX–
POE positive
Spare pair
POE negative
Spare pair
POE negative
7