Dell PowerConnect B-RX4 설치 매뉴얼 - 페이지 7

{카테고리_이름} Dell PowerConnect B-RX4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect B-RX4 17 페이지. Instant access point
Dell PowerConnect B-RX4에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

페이지 인쇄

5. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-degree

angle to the ceiling tile rail (see

6. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into place on the ceiling tile rail.

Figure 4

7. On the W-AP134, install the external antennas according to the manufacturer's instructions, and connect the

antennas to the antenna interfaces on the AP.

Connecting Required Cables

Install cables in accordance with all applicable local and national regulations and practices.

Ethernet Ports

The RJ-45 Ethernet ports (ENET0 and ENET1) support 10/100/1000Base-T auto-sensing MDI/MDX

connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to an Dell

PowerConnect Controller. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet) long.

The 10/100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female connectors

with the pin-outs shown in .

Table 1

Connector

Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide

Mounting the AP

Ethernet Port Pin-out

Signal

Name

BI_DA+

BI_DA–

BI_DB+

BI_DC+

BI_DC–

BI_DB–

BI_DD+

BI_DB–

Figure

4). Make sure that any cable slack is above the ceiling tile.

GE Connection

Bi-directional pair A+

Bi-directional pair A–

Bi-directional pair B+

Bi-directional pair C+

Bi-directional pair C–

Bi-directional pair B–

Bi-directional pair D+

Bi-directional pair D–

PoE

Connection

RX+

POE negative

RX–

POE negative

TX+

POE positive

Spare pair

POE positive

Spare pair

POE positive

TX–

POE positive

Spare pair

POE negative

Spare pair

POE negative