Dell PowerEdge M520 Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih Dell PowerEdge M520. Dell PowerEdge M520 26 halaman. Dell poweredge blade servers getting started guide
Juga untuk Dell PowerEdge M520: Pembaruan Informasi (38 halaman), Catatan Rilis (27 halaman), Manual (25 halaman), Panduan Pengguna (23 halaman), Panduan Informasi Penting (35 halaman), Manual Pembaruan (32 halaman), Manual Pembaruan (28 halaman), Panduan Pengguna (22 halaman), Panduan Memulai (12 halaman), Panduan Teknis (46 halaman), Panduan Teknis (45 halaman), Panduan Portofolio (27 halaman), Panduan Memulai (14 halaman), Panduan Memulai (12 halaman)

Halaman Cetak

Dell 10Gb Ethernet Pass Through II

Command name

show port module

Debug Commands

cr_read

cr_write

3.3

CLI Command Reference Conventions

This section describes the 10GbE PTM CLI commands.

For each command, the following information is provided:

• Synopsis:

Lists the command name and any required or optional parameters. Variable parameters (like port

numbers) are shown in italics. Optional parameters are shown in square brackets, e.g.

[optional_parameter]. Required parameters are shown with no brackets.

• Description:

Provides a detailed description of the command and of all its parameters

• Example:

Usage example and command output.

For purpose of automation, the symbol '#' is used to indicate a comment that extends until the

next new-line character.

3.4

General Commands

3.4.1

help

Synopsis:

help

Description:

Show the list of all available commands.

ADMIN: when in ADMIN mode, this command will also show commands that require

ADMIN privilege level.

Example:

# help

Table 5 - List of Commands

Short Description

Shows uplink module parameters

To read a 32 bit register from device number

device_num.

To write a data DWORD to address

0xHex_address to device number

device_num.

Reference

Section 3.7.2, "show port module," on

page 17

Section 3.8.1, "cr_read (ADMIN)," on

page 17

Section 3.8.2, "cr_write (ADMIN)," on

page 18

Rev 1.00