Dell PowerEdge M620 Manual - Halaman 16

Jelajahi secara online atau unduh pdf Manual untuk Beralih Dell PowerEdge M620. Dell PowerEdge M620 25 halaman. Dell poweredge blade servers getting started guide
Juga untuk Dell PowerEdge M620: Pembaruan Informasi (38 halaman), Catatan Rilis (27 halaman), Panduan Pengguna (23 halaman), Panduan Informasi Penting (35 halaman), Manual Pembaruan (32 halaman), Manual Pembaruan (28 halaman), Panduan Pengguna (26 halaman), Panduan Pengguna (22 halaman), Panduan Memulai (12 halaman), Panduan Memulai (12 halaman), Panduan Teknis (46 halaman), Panduan Teknis (49 halaman), Panduan Portofolio (27 halaman), Panduan Teknis (44 halaman), Panduan Memulai (14 halaman), Panduan Memulai (12 halaman)

Rev 1.00

Description:

Use this command to restart the module components. When this command is issued, PTM compo-

nents go through a full hardware reset, followed by software reload.

Options:

• device_number: specify a single device to reset

Example:

$ reload

3.5

Software Update Commands

Synopsys:

show image ver

Description:

Display the current software image version.

ADMIN: This command also displays the firmware version of each component.

Example:

# login admin

& show image ver

Software image short version: V Z.ZZ

Software image version: X.X.XXX-<date stamp>

Component #1 firmware version: Y.Y.YYY

Component #2 firmware version: Y.Y.YYY

Component #3 firmware version: Y.Y.YYY

& login user

Synopsys:

copy image from-file [device_number]

Description:

Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a

single device in the PTM. Immediately after running this command, the CLI waits for the user to

send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For

additional details on the firmware update procedure refer to

on page 22

ADMIN:

Section 4, "Operating Procedures,"

Software User's Manual