Dell S6010-ON Catatan Rilis Firmware - Halaman 5

Jelajahi secara online atau unduh pdf Catatan Rilis Firmware untuk Beralih Dell S6010-ON. Dell S6010-ON 12 halaman.
Juga untuk Dell S6010-ON: Panduan Instalasi (46 halaman)

Halaman Cetak
Dell S6010-ON Catatan Rilis Firmware
BIOS
Downgrading BIOS is not supported. You can only upgrade to the latest BIOS version.
Marginal reset timing change
Changed the marginal reset timing for out-of-band (OOB) the management port.
BIOS version numbering change
The BIOS version nomenclature has changed. The version X.Y.Z.U-V:
X
The processor family. For example, 3 for X86 on an S6010-ON switch.
Y
The platform ID within the processor family. For example, the S6010-ON switch is 26.
Z
The image type. For example, BIOS = 0.
U
The bit definitions for the BIOS are:
V
The image version.
Additional BIOS information
● Updated Microcode for Spectre/Meltdown from version M01406D8125 to M01406D812A.
○ CVE-2018-3639, Spectre/Variant #4, and CVE-2018-3640, Spectre/Variant #3a, are addressed by applying the updated
processor microcode from Intel included in this release.
○ This BIOS revision includes the updated processor microcode that is a required part of the mitigation for CVE-2018-3639,
Spectre/Variant #4, and CVE-2018-3640, Spectre/Variant#3a.
● Changed the Intel Reference Code from version 1.0.0.43 to 1.0.0.48 to support higher-density DIMMs.
● Added the critical device feature for POST to detect if an OS-critical device is missing or misconfigured.
ONIE self-update
WARNING:
Do not power-cycle the board when an ONIE self-update is in progress. If the install or upgrade task
is interrupted, the board might have an invalid MBR/GPT/Grub, and would not boot into ONIE. In this case, use
a recovery procedure to bring up the switch so long as the BIOS is functional.
I2C bus
NOTE:
After a thermal shutdown, the I2C bus could lock up occasionally. If this action happens, you must manually power
cycle the switch.
Table 3. BIOS bit definitions
Bit
0
1
2
3
4
5
Feature
Partition
Baud rate
N/A
PXE
N/A
Bootloader
State
0=MBR, 1=UEFI
0=115200, 1=9600
N/A
0=not supported
N/A
0=AMI BIOS
5