Allied Telesis AT-8948 Cara Mengkonfigurasi - Halaman 6

Jelajahi secara online atau unduh pdf Cara Mengkonfigurasi untuk Catu Daya Allied Telesis AT-8948. Allied Telesis AT-8948 9 halaman. At-8900 series
Juga untuk Allied Telesis AT-8948: Lembar data (4 halaman), Lembar data (3 halaman), Lembar data (3 halaman), Lembar data (2 halaman), Lembar data (5 halaman), Ikhtisar (1 halaman), Brosur (8 halaman), Panduan Tambahan (6 halaman), Panduan Pemasangan Cepat (13 halaman)

Core 2 (backup) configuration

The configuration is very similar to core 1, with the following differences:

the switch has a different name

the STP priority value is higher, so core 2 is never the root bridge when core 1 is available

the VLAN IP addresses are different (but the VRRP virtual IP addresses are the same)

the VRRP priority is left at the default value of 100.

The complete configuration is:

Page 6 | AlliedWare™ OS How To Note: VRRP

set system name=backup

create vlan=vlan2 vid=2

create vlan=vlan3 vid=3

...

enable stp=default

set stp=default priority=16384 mode=rapid

set vlan=1 port=1,23-24 frame=tagged

add vlan=2 port=2,23-24 frame=tagged

add vlan=3 port=3,23-24 frame=tagged

...

delete vlan=1 port=1-24

create switch trunk=example port=23-24

enable ip

add ip int=vlan1 ip=192.168.1.2

add ip int=vlan2 ip=192.168.2.2

add ip int=vlan3 ip=192.168.3.2

...

enable vrrp

create vrrp=1 over=vlan1 ipaddress=192.168.1.3 adoptvrip=on

create vrrp=2 over=vlan2 ipaddress=192.168.2.3 adoptvrip=on

create vrrp=3 over=vlan3 ipaddress=192.168.3.3 adoptvrip=on

...

Core 2 (backup) configuration