Allied Telesis AT-8948 How To Configure - Page 6

Browse online or download pdf How To Configure for Power Supply Allied Telesis AT-8948. Allied Telesis AT-8948 9 pages. At-8900 series
Also for Allied Telesis AT-8948: Datasheet (4 pages), Datasheet (3 pages), Datasheet (3 pages), Datasheet (2 pages), Datasheet (5 pages), Overview (1 pages), Brochure (8 pages), Supplementary Manual (6 pages), Quick Install Manual (13 pages)

Print Page

Core 2 (backup) configuration

The configuration is very similar to core 1, with the following differences:

the switch has a different name

the STP priority value is higher, so core 2 is never the root bridge when core 1 is available

the VLAN IP addresses are different (but the VRRP virtual IP addresses are the same)

the VRRP priority is left at the default value of 100.

The complete configuration is:

Page 6 | AlliedWare™ OS How To Note: VRRP

set system name=backup

create vlan=vlan2 vid=2

create vlan=vlan3 vid=3

...

enable stp=default

set stp=default priority=16384 mode=rapid

set vlan=1 port=1,23-24 frame=tagged

add vlan=2 port=2,23-24 frame=tagged

add vlan=3 port=3,23-24 frame=tagged

...

delete vlan=1 port=1-24

create switch trunk=example port=23-24

enable ip

add ip int=vlan1 ip=192.168.1.2

add ip int=vlan2 ip=192.168.2.2

add ip int=vlan3 ip=192.168.3.2

...

enable vrrp

create vrrp=1 over=vlan1 ipaddress=192.168.1.3 adoptvrip=on

create vrrp=2 over=vlan2 ipaddress=192.168.2.3 adoptvrip=on

create vrrp=3 over=vlan3 ipaddress=192.168.3.3 adoptvrip=on

...

Core 2 (backup) configuration