EarthQuake Mpower8 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembicara EarthQuake Mpower8. EarthQuake Mpower8 8 halaman. Studio powered monitor

Halaman Cetak

Amplifier Features

USE ONLY WITH AC 250V FUSE

1. Unbalanced RCA Input

RCA input for connecting the MPower monitor to your TV,

computer, DJ equipment, mobile device, etc.

2. Balanced 1/4" TRS Input

10kOhm balanced TRS input for connecting

monitor to

your audio interface or mixer. For best result, be

sure to use a balanced 1/4" TRS phone plug.

3. Balanced XLR Input

10kOhm balanced XLR input for connecting

monitor to

your audio interface or mixer.

NOTE:

Tip

↔

Pin 1

Sleeve (Shield) = Ground (cable shield)

↔

Pin 2

Tip = Positive/Red/Hot

↔

Pin 3

Ring = Negative/Black/Cold

CONNECT ONLY ONE INPUT SOURCE AT A TIME.

Earthquake Sound Corp. | (510) 732-1000 | www.earthquakesound.com

-80dB

the MPower

Balanced TRS

Ring

Sleeve

Unbalanced TS

4. Main Power Switch

This switch controls the AC power going to the MPower

monitor. We suggest keeping the switch in the OFF

position when the monitor is not being used for an

extended period of time.

5. 110V/220V Selector Switch

The MPower monitors can operate in a 110-120V or 220-

240V environment.

required power input setting and replace the fuse to the

proper rating prior to connecting the monitors to the

power source.

USE OF IMPROPER VOLTAGE MAY RESULT IN

HAZARDOUS CONDITIONS AND/OR DAMAGE TO THE

MONITOR COMPONENTS THAT ARE NOT COVERED

BY THE FACTORY WARRANTY.

FOR YOUR SAFETY, PLEASE MAKE SURE THAT THE

MONITOR IS NOT CONNECTED TO ANY POWER

SOURCE PRIOR TO ACCESSING THE AC SELECTOR

AND FUSE COMPARTMENT.

6. AC Power Inlet with Fuse Holder

This AC line connector is fused to protect the amplifier from

unwanted power surges. Be sure to use the proper fuse

USE ONLY WITH AC 250V FUSE

rating when replacing the existing fuse:

M6: ø5 x 20mm 2A/250V UL/VDE slow blow tube fuse

M8: ø5 x 20mm 3.15A/250V UL/VDE slow blow tube fuse

To access the fuse compartment, simply

unplug the power cable from the monitor,

place a flat-head screw driver in the small

notch and pry it open as illustrated.

7. Volume Control

This volume knob controls the MPower monitor's input

sensitivity. Typically, you would want to set this knob to the

maximum setting (+6dB), adjust the source's output level

and then use this volume knob to match the left and right

MPower monitors.

8. HF Adjustment

This high frequency adjustment is factory set at 0dB.

Simply adjust accordingly to your listening preference.

Specifications are subject to change without notice

Simply slide the selector to the

USE ONLY WITH AC 250V FUSE