Miele PW 6321 Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin cuci Miele PW 6321. Miele PW 6321 46 halaman.
Juga untuk Miele PW 6321: Petunjuk Pengoperasian dan Pemasangan (44 halaman), Petunjuk Pengoperasian dan Pemasangan (44 halaman), Manual Petunjuk Pemrograman (48 halaman)

Miele PW 6321 Panduan Petunjuk Pengoperasian
Warning and Safety instructions
The washer-extractor may only be
operated without supervision if there is a
floor drain (gully) in the immediate vacinity.
If the washer-extractor is switched off
and the drum door is closed, you need
to switch the machine on before you can
open the door.
If water comes out of the suds container
when the door is opened, close the door and
switch the washer-extractor on. Drain the
water away before you try and open the
door.
It is the operator's responsiblity to ensure
that the standard of disinfection in
thermal as well as chemo thermal
procedures is maintained (in accordance
with § 18 IFSG and national health and
safety regulations) by carrying out suitable
validation tests. These procedures should
be checked on a regular basis, either
thermo-electrically using loggers, or
bacteriologically with bio indicators. The
operator must pay particular attention to
maintaining the correct parameters in the
procedure, including temperature and with
chemo thermal programmes, the chemical
concentration used. Disinfection
programmes must not be interrupted, as this
can have a limiting effect on the disinfection
result.
It is particularly important to observe
manufacturer's instructions when using a
combination of cleaning agents and special
application products. Only use the product
for the application described by the
manufacturer, to avoid any material damage
or the occurrence of strong chemical
reactions.
Confirm with the detergent manufacturer that
their product can be used in combination
with another type of product.
Only use dyes, colour run and dye
removers specified as being suitable for
use in washing machines. Always observe
the manufacturer's instructions carefully.
Laundry that was soiled with biological
oils or fat should be washed using a
suitable detergent and /or wash programme.
It must also be inspected after washing. If
oils or fat are not sufficiently removed they
could cause the laundry to self ignite during
the drying process. This type of soiling
6
should be removed using specialist
detergents and/or programmes.
Do not use a pressure washer or hose to
clean the machine.
Further notes
Cleaning and disinfecting agents often
contain chlorine-based substances. Do
not let such agents dry out on stainless steel
surfaces, as the chlorine can have a
corrosive effect. Use chlorine-free agents for
washing and disinfecting and also for
cleaning stainless steel surfaces to protect
them from corrosion.
If in doubt, confirm with the manufacturer
that their product is suitable. If any agent
containing chlorine comes into contact with
the stainless steel surfaces, wipe it away
immediately with clean water. Then dry with
a soft cloth.
The manufacturer cannot be held liable
for the effect of a chemical cleaning
agent on laundry or the machine, even when
the use of such agents is recommended.
Please note that changes to the product
which have not been made known by the
manufacturer can affect the quality of the
wash result.
Using accessories
Accessory parts may only be fitted when
expressly approved by Miele. Using
spare parts or accessories from other
manufacturers will invalidate the guarantee,
and Miele cannot accept liability.
Any additional components used, e.g.
suction devices for liquid agents,
electronic water meters or dispenser
monitors, must conform to Safety Class II.
If connected to an external PC, this must
conform to EN 60950-1:2001 (IEC
60950-1:2001).
M.-Nr. 06 572 495