Allmand Night-Lite E Series Panduan Operator - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Pencahayaan Allmand Night-Lite E Series. Allmand Night-Lite E Series 20 halaman. Portable light tower

Halaman Cetak

8. Close and latch the control panel

door.

9. Disconnect the power cord from the

120-volt power source and the power

outlet on the side of the unit.

10. Remove the wheel chocks from the

wheels of the unit.

The unit is now ready for transport. See

Transporting.

WARNING

• Do not remove the wheel chocks

from the front and back of the

wheels until the portable light tower

is ready to be transported. Doing

so could result in death or serious

injury.

Maintenance

Before performing any maintenance

procedures, read Safety.

Where equipment is operated under

severe conditions (very dusty, extreme

heat or cold, etc.), affected items

should be serviced more frequently.

WARNING

Operating a machine with worn, dam-

aged or missing parts can result in

death or serious injury. Always replace

worn, damaged or missing parts

promptly. Do not operate this machine

until all worn, damaged or missing

parts have been replaced, and proper

operation of the machine has been

verified.

General Maintenance

1. Inspect the light tower mast, cables,

light fixtures, frame, and all compo-

nents for wear, damage or corrosion.

Repair or replace as needed.

2. Check to be sure all hardware is

securely tightened.

3. Inspect the wheels for wear or dam-

age. Replace as needed.

4. Inspect the outrigger bars, stabilizer

jacks and locking pins for proper

operation, and for wear, damage or

corrosion. Replace as needed.

Cleaning

WARNING

Entanglement Hazard

• Failure to disconnect the power

before cleaning the unit could result

in death or serious injury. Always

disconnect the power before clean-

ing the unit.

WARNING

Burn Hazard

• Shut down the lights and allow

ample time for components to cool

before cleaning the unit. Failure to

do so could result in serious burns.

NOTICE

Use caution when using compressed

air or water / steam pressure washers.

Do not pressure–clean electrical com-

ponents, as this may cause damage.

• Clean the portable light tower to

remove all dust, dirt or other foreign

material.

• Clean the light fixture assemblies with

a damp cloth or sponge.

• Clean all electrical wiring and com-

ponents by hand using non-corrosive

cleaner.

• Open the control panel door and

clean the control panel.

Model And Serial Number

Model and serial number information is

required for product support and repair

parts. The serial number plate for the

portable light tower is located on the

unit base.