Miele DA 289 Petunjuk Pengoperasian dan Pemasangan - Halaman 17
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi Miele DA 289. Miele DA 289 32 halaman. Decorator wall hood accessory shelving unit
Juga untuk Miele DA 289: Dimensi Produk (2 halaman), Dimensi Produk (2 halaman), Panduan Pengoperasian dan Instalasi (36 halaman)
Halaman Cetak
^ Clean the filter
– by hand: with a soft nylon brush,
warm water and a little washing up
liquid.
– in a dishwasher: place the filter
with the short side upright in the
lower basket, ensuring the spray arm
is not obstructed.
Depending on the cleaning agent
used, cleaning the grease filter in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the func-
tioning of the grease filter in any way.
^ After cleaning, leave the filter to dry
for a while on an absorbent surface
before putting it back in place.
^ When cleaning the vapour plate,
please follow the instructions given
under "Housing" earlier in this sec-
tion.
^ With the vapour plate and grease fil-
ter removed, clean off any residues of
oil or fat from the now accessible
housing and channel on the lower
housing to prevent the risk of these
catching fire.
^ After replacing the vapour plate and
grease filter press the grease filter
touch control for approx. 3 seconds
to re-set the operating hours counter.
The indicator lamp will go out.
^ If the vapour plate and grease filter
are cleaned before the operating
hours counter has reached its maxi-
mum, the grease filter touch control
should be pressed for approx. 6 sec-
onds to reset the counter to zero.
Cleaning and care
^ Push the grease filter into position un-
til it engages.
^ Hook the vapour plate into the bottom
of the housing, push it slightly to the
left and then raise it up towards the
appliance and click it into position.
17