HP 234664-002 - ProLiant - ML330T02 Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Desktop HP 234664-002 - ProLiant - ML330T02. HP 234664-002 - ProLiant - ML330T02 15 halaman. Visualization and acceleration in hp proliant servers
Juga untuk HP 234664-002 - ProLiant - ML330T02: Pertanyaan yang Sering Diajukan (4 halaman), Panduan Pelaksanaan (35 halaman), Buku Putih Teknis (12 halaman), Pembaruan Firmware (9 halaman), Ikhtisar (20 halaman), Panduan Pelaksanaan (26 halaman), Panduan Pengenalan (22 halaman), Panduan Pemecahan Masalah (18 halaman), Panduan Pelaksanaan (11 halaman), Panduan Instalasi (2 halaman), Panduan Konfigurasi (2 halaman), Panduan Pengenalan (19 halaman), Manual Pembaruan (9 halaman), Manual Pembaruan (16 halaman), Panduan Pengenalan (10 halaman), Ringkasan Teknologi (9 halaman)

Select the Microsoft Windows Standard Server 2003 SBS link from the left navigational menu on

the CD Home page. Then, follow the online instructions to create the driver media.

Set aside the storage driver media for use during the installation of Microsoft Windows SBS 2003

R2.

Part 2: Installing Windows SBS 2003 R2

This section defines the tasks necessary for the Windows SBS 2003 R2 installation.

NOTE:

The installation steps in this section are for a default OS installation

to the C: hard drive partition. Additional logical volumes or disk

partitions can be created; however, different steps or choices may

be necessary during the OS installation. Refer to the Microsoft

Windows SBS 2003 R2 documentation for help in planning

customized installations.

On the ProLiant server receiving the Windows SBS 2003 R2 installation, complete these steps:

NOTE:

A Server Support and Documentation CD ships with ProLiant

ML100 series servers. A later version of the drivers may be

obtained from: www.hp.com/servers.

Power On the server.

Insert the Microsoft Windows SBS 2003 R2 CD-ROM #1 into the CD-ROM drive.

If a previous OS exists on the server, press any key to boot from the CD. If an OS does not exist

on the server, the Windows Setup screen automatically displays.

When the Windows Setup screen displays, press the F6 key within approximately three seconds to

install a third-party storage driver (Figure 1):

Figure 1 Windows Setup screen