HP 3000 Series Panduan Peningkatan - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Peningkatan untuk Desktop HP 3000 Series. HP 3000 Series 19 halaman. 9x9 to k class conversion
Juga untuk HP 3000 Series: Manual (25 halaman), Manual (20 halaman), Panduan Instalasi (42 halaman)

HP 3000 Series Panduan Peningkatan
HP3000/979KS/989KS and HP9000/K250/K260/K370/K380/K450/K460 and
Figure 1-7
K570/K580
1. Remove the sheetmetal case.
2. Identify the next available CPU slot in sequence. Carefully reach into the computer cabinet and
remove the CPU connector dust cover by grasping the extended tab and pulling it out. Only remove
the dust cover(s) necessary to install the desired number of CPUs.
3. Remove the protective dust cover from the CPU card and carefully align the CPU card into the
appropriate slot. Be sure the air guide and card components are on the right-hand side of the card
during installation.
NOTE
CPUs 4 and 5 will use snap-in guides that should be installed in your server.
4. Insert the CPU card until it contacts the system board connector, then press firmly to seat the card.
NOTE
If there are more CPUs to add, proceed to the appropriate Adding a CPU Card steps. If
there are no more CPUs to add, proceed to Installation Verification.
5. Replace the back CPU cover plate and tighten all captive mounting screws.
After performing CPU installation steps, replace the power supply according to the instructions in the
preceding HP3000/979KS/989KS and HP9000/K250/K260/K450/K460/Kx70 and Kx80 Power
Supply Replacement section.
CPU locations
CPU Upgrade
Adding a CPU Card
9