HP 3000 Series 업그레이드 매뉴얼 - 페이지 14

{카테고리_이름} HP 3000 Series에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 3000 Series 19 페이지. 9x9 to k class conversion
HP 3000 Series에 대해서도 마찬가지입니다: 매뉴얼 (25 페이지), 매뉴얼 (20 페이지), 설치 매뉴얼 (42 페이지)

페이지 인쇄

HP3000/979KS/989KS and HP9000/K250/K260/K370/K380/K450/K460 and

Figure 1-7

K570/K580

1. Remove the sheetmetal case.

2. Identify the next available CPU slot in sequence. Carefully reach into the computer cabinet and

remove the CPU connector dust cover by grasping the extended tab and pulling it out. Only remove

the dust cover(s) necessary to install the desired number of CPUs.

3. Remove the protective dust cover from the CPU card and carefully align the CPU card into the

appropriate slot. Be sure the air guide and card components are on the right-hand side of the card

during installation.

NOTE

CPUs 4 and 5 will use snap-in guides that should be installed in your server.

4. Insert the CPU card until it contacts the system board connector, then press firmly to seat the card.

NOTE

If there are more CPUs to add, proceed to the appropriate Adding a CPU Card steps. If

there are no more CPUs to add, proceed to Installation Verification.

5. Replace the back CPU cover plate and tighten all captive mounting screws.

After performing CPU installation steps, replace the power supply according to the instructions in the

preceding HP3000/979KS/989KS and HP9000/K250/K260/K450/K460/Kx70 and Kx80 Power

Supply Replacement section.

CPU locations

CPU Upgrade

Adding a CPU Card