AllPondSolutions EF2+ Manual - Halaman 2
Jelajahi secara online atau unduh pdf Manual untuk Akuarium AllPondSolutions EF2+. AllPondSolutions EF2+ 20 halaman. Aquarium external filters
To ensure your new external filter is set up and running correctly, and to prevent
any accidental damage or injury, please read and follow the below instructions
carefully before using your product.
SAFETY
IMPORTANT!
Disconnect the mains electricity supply before attempting any installation /
maintenance of any kind. Do not attempt to modify this unit in any way and only use the
recommended parts for replacement.
The external filter should never be run dry as this will cause the unit to overheat
and cause permanent damage.
All connections must be earthed.
The power cord of this appliance cannot be replaced; if the cord is
damaged, the appliance should be discarded. Never cut the cord.
Do not connect to any voltage other than that stated.
This filter is suitable for indoor household aquariums only (do not use in exterior
locations, swimming pools, ponds, bathrooms etc). Do not place in liquids other than
water.
Do not use with water above 90°F or 30°C.
Do not carry or pull the unit by its electrical cable.
Do not use this unit if it has a damaged cord or plug, if it is malfunctioning or it is
dropped or damaged in any manner
Do not yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use.
Do not attempt to modify this unit in any way and only use the
recommended parts for replacement.
Before installing, maintaining or handling your equipment, or before placing your hands
in your aquarium, ensure that the unit is disconnected from the electricity supply.
Always unplug any electrical devices when not in use.
Carefully examine your filter after installation. Do not plug in the unit to the mains if
there is water on any parts not intended to be wet.