Miller Axcess 300 Panduan Pemilik - Halaman 22
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller Axcess 300. Miller Axcess 300 36 halaman. Arc welding power source and wire feeder with meters
Juga untuk Miller Axcess 300: Panduan Pemilik (44 halaman), Panduan Pemilik (48 halaman)
Halaman Cetak
SECTION 4 – MAINTENANCE &TROUBLESHOOTING
4-1. Routine Maintenance
3 Months
Replace unreadable labels
Clean and tighten weld terminals
6 Months
Blow out or vacuum inside.
4-2. Circuit Breakers CB1 And CB2
1
2
4-3. Unit Overload
If unit is used beyond capacity (excessive wire feed, shorted output, etc.), wire feeds but is not energized. Release gun
trigger to reset this condition.
OM-1317 Page 18
OR
4
Y Disconnect power
before maintaining.
Repair or replace
cracked weld cable
Remove drive roll and
carrier. Apply light coat
of oil or grease to drive
motor shaft.
3
.
Maintain more often
during severe conditions.
1
Circuit Breaker CB2
CB2 protects Remote 14 recep-
tacle RC1 from overload.
2
Circuit Breaker CB1
If CB1 opens, wire feeding stops.
3
Welding Gun (Not Included)
Check gun liner for blockage or
kinks.
4
Wire Drive Assembly
Check for jammed wire, binding
drive gear or misaligned drive rolls.
Allow cooling period and reset
breaker. Close door.
Ref. ST-801 770