Miller XR-15W Panduan Pemilik - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XR-15W. Miller XR-15W 36 halaman. With quick disconnect ce, 200/400 ampere air/water push-pull welding gun

Halaman Cetak

1. Replacing the Gun Liner
2. Section 8 − Electrical Diagrams
3. Section 9 − Parts List
4. Section 10 − Parts List Including Consumables

5-7. Adjusting Tension At Feeder

0.030 - 0.035 in.

Tools Needed:

Tension Arm

Open tension arm.

Install proper size drive rolls.

Thread wire thru inlet guide, along drive roll groove, and

into wire conduit. Close tension arm. Adjust tension as

follows:

Tension Settings

Wire Size

Welding

1−2

0.040 in.

3−4

3/64 in.

1/16 in.

Hold wire tightly to keep

it from unraveling.

6 in.

(150 mm)

Pull and hold wire; cut off end.

Gun Calibration

3−4

Ref. 805 350-A / 242 517-A

OM-236297 Page 13