Miller XR-15W Kullanıcı El Kitabı - Sayfa 17
Kaynak Sistemi Miller XR-15W için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller XR-15W 36 sayfaları. With quick disconnect ce, 200/400 ampere air/water push-pull welding gun
Sayfayı Yazdır
5-7. Adjusting Tension At Feeder
0.030 - 0.035 in.
Tools Needed:
1
1
Tension Arm
Open tension arm.
Install proper size drive rolls.
Thread wire thru inlet guide, along drive roll groove, and
into wire conduit. Close tension arm. Adjust tension as
follows:
Tension Settings
Wire Size
Welding
1−2
0.040 in.
3−4
3/64 in.
1/16 in.
.
Hold wire tightly to keep
it from unraveling.
6 in.
(150 mm)
Pull and hold wire; cut off end.
1
Gun Calibration
3−4
Ref. 805 350-A / 242 517-A
OM-236297 Page 13