Miller Spoolmatic 30A Panduan Pemilik - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Aksesori Pengelasan Miller Spoolmatic 30A. Miller Spoolmatic 30A 36 halaman. Welding guns
Juga untuk Miller Spoolmatic 30A: Panduan Pemilik (32 halaman), Panduan Pemilik (32 halaman)
Halaman Cetak
5-4. Installing Wire Spool And Threading Welding Wire
1
11
Tools Needed:
OM-264 713 Page 10
2
3
4
5
6
7
8
9
10
1
Pressure Arm Lever
.
To release drive roll pressure,
pull back on pressure arm
lever. While pulled back, shift to
left onto shoulder to lock into
place.
2
Canister Inlet Guide
3
Drive Roll Grove
4
Top Cover
5
Thumbscrew (Canister
Rotation)
Loosen thumbscrew to rotate can-
ister (see Section 5-6).
6
Canister
7
Spool Brake Thumbnut
If necessary, turn thumbnut coun-
terclockwise slightly to install spool.
8
Canister Cover
9
Thumbscrew (Canister Cover)
Loosen thumbscrew and remove
cover.
10 Wire Spool
Loosen wire from spool, cut off bent
wire, and pull 6 in. (150 mm) of wire
off spool.
11 Contact Tip
Thread wire through canister inlet
guide, along drive roll groove, and
out contact tip.
Install spool so wire feeds off
bottom.
Close and secure pressure arm
lever.
Reinstall top cover and canister
cover.
Ref. T0052-B / T0061