AQUAPHOR DWM-203 Manual Kinerja - Halaman 6

Jelajahi secara online atau unduh pdf Manual Kinerja untuk Sistem Penyaringan Air AQUAPHOR DWM-203. AQUAPHOR DWM-203 16 halaman.

Halaman Cetak

The installation of junction point* (fig. 4)

• Turn the water off at the mainline on the highway of cold

water-supply.

• Open the kitchen mixer tap in order to depressurize water

pipe.

• Unscrew cap nut of flexible connection at the mainline on the

highway of cold water-supply, stand for mixer tap.

ATTENTION! In the flexible tube, after a pressure

release, a small amount of water may remain. When

disconnecting the flexible connector, use a capacity

of about 200 ml to drain the remaining water in the

tube.

• Screw the cap nut of the junction point to the threads of

mainline on the highway of cold water-supply.

ATTENTION! Ensure that the seal pad is in place and

is not damaged when mounting the product.

• Screw the cap nut of flexible connection on the threads of

junction point.

• Close the inlet tap of the connection unit and, having supplied

water from the cold water supply line, make sure that the

connection is hermetically sealed.

• Joint the tube JG.

* * The manufacturer reserves the right to use the connection points and cranes of a similar design. If you have any questions, please contact the service provider.

Fig. 5а

Fig. 5b

Inlet tap set to position

«Closed»

Key lock clip

Junct

ion point

Seal pad

Cold water-

supply

Fig. 4

How to connect the pipes JG (fig. 5a) Pull

out the key lock clip from under the plastic

sleeve, insert the pre-tipped end of the tube into

the choke bean to the depth of about 15 mm to

the stop and emplace the clip.

How to disconnect the pipes JG (fig. 5b)

Pull the locking clip out from under the plastic

sleeve and, pressing the end of the plastic

sleeve, pull out the tube.

Check the strength of the tube. At

an effort of 8-10 kgf the tube

should not be pulled out.