AQUAPHOR RO-312S PRO Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem Penyaringan Air AQUAPHOR RO-312S PRO. AQUAPHOR RO-312S PRO 17 halaman. Reverse osmosis system

Halaman Cetak

AQUAPHOR RO-312S PRO Panduan Pengoperasian

Installation

guide

ATTENTION! To connect the RO-312S Pro, it is

recommended to contact the service department

of Aquaphor or regional dealers of Aquaphor.

Installing the RO-312S Pro

1. For installation you will need: drill, drill 7 mm

and 12 mm, adjustable wrench, screwdriver,

pipe wrench 14 mm.

2. Determine the convenient location of the tip

for clean water and the working unit, the in-

stallation site of the water supply node and

drainage clamp.

Make sure that the connecting tubes pass freely,

without kinks. The free sections of the tubes

should be fixed so that they cannot be damaged

or pulled out of the joints by foreign objects. The

RO-312S Pro must be isolated or isolated from

heat sources (dishwashers, washing machines,

stoves, boilers, hot water pipes, etc.).

Install the storage tank where the transfusion

of water beyond its edges cannot lead to unde-

sirable consequences.

Install a connection node

ATTENTION! The end of the pipeline to which

the connection unit is connected must be flat.

When installing the connection unit, do not use

excessive force so as not to damage it. If there

is mechanical damage to the connection unit as

a result of improper installation and / or improper

use, claims will not be accepted.

3. Shut off the cold water line and relieve pres-

sure by opening the mixer.

4. Install a connection unit (5) between the cold

water supply system and the flexible con-

nection of the mixer. If necessary, use the

FUM tape to seal the external thread of the

connection unit.

5. Connect the inlet pipe (red). See the "Con-

necting Tubes" section.

Water purifier installation

1. Collector block with drain pipe

2. Water treatment unit

3. Membrane block

4. Mineralizer

5. Connection node

6. Drain clamp

7. Tip for clear water with a tube

8. Decorative stand

9. Rubber gasket

10. Plastic washer

11. Metal lock washer

OSMO PRO

Collector Block Installation

6. To install the collector block (1), use the hard-

ware provided. Drill two holes for self-tapping

screws at a distance of 110 mm from each other

at the installation site of the RO-312S Pro. Fix

the collector block so that with installed car-

tridges at least 50 mm of free space is left

under the water purifier. This is necessary for

the convenience of replacing filter cartridges

and installing a drainage tube. Pay attention to

the supply tubes passing freely, without kinks.