Aquaport AQP-20SIL Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Dispenser Air Aquaport AQP-20SIL. Aquaport AQP-20SIL 16 halaman. Signature filtered water cooler

Halaman Cetak

1. Installation Instructions

B. OPERATION INSTRUCTIONS

WARNING: Do not use with water that is microbiologically unsafe

or of unknown quality without adequate disinfection before or after the

system.

WARNING: Do not connect power to unit until water flows from all taps

Wash all filter bottle parts (except filter cartridge) with warm water

and detergent and rinse thoroughly. In addition, flush clean water

through the unit and drain out via the taps and drain plug located at the

rear of the unit. Tilt the unit back and forth to remove trapped water

from unit. Continue this process until no more water runs

out of the drain.

Remove Filter Cartridge (1) from plastic, make sure not to lose the

filter cartridge O ring. Immerse filter in ambient water for 20 minutes.

Shake filter under water to remove any excess black carbon particles

and trapped air.

Note: You may see small amounts of black particles at times; these are

small pieces of carbon from the filter. These carbon particles are food grade

and are not harmful. They will not impair the performance of your filter or

unit

Ensure drain plug (14) is secure on the unit and tighten in place.

Ensure that the Filter Bottle O ring (7) is seated in the channel at the

top of the cooling unit. See Figure 1 for location.

WARNING: If Filter bottle O ring (7) is not in place or correctly seated

leaking may occur. When the filter bottle is removed special care must be

taken to ensure this part is not lost. Always ensure the O ring is correctly

seated prior to installing the filter bottle.

Place filtered water chamber (6) onto the water cooler unit and push

down. There should be no gap between the cooling unit and the filtered

water Chamber (6)

Lock the filtered water chamber (6) into position using the filter

bottle screw nut (15). Turn filter bottle screw nut (15) in a clockwise

direction. Tighten by hand only, do not over tighten. See figure 2.

Place unfiltered water chamber (5) into the filtered water chamber (6)

Install Filter cartridge O ring (2) onto the unfiltered water chamber filter

thread then screw the filter cartridge into place.

Pour water into the unfiltered water chamber (5); allow water to filter

through to the filtered water chamber (6).

Fig 1

Fig 2

Channel for

Filter bottle

O Ring

Aerial view

of cooling

unit with

filter bottle

removed

INSTALLATION AND OPERATING INSTRUCTIONS 5

screw nut