Aquaport AQP-FKM3 Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Sistem Penyaringan Air Aquaport AQP-FKM3. Aquaport AQP-FKM3 17 halaman.
Halaman Cetak
D. Tubing Installation
The Filtration System has been supplied with quick and easy to
install quick connections.
To install tubing, push tubing into connections, and give a slight
pull to ensure tubing is secure:
Note: Check the end of the tubing to make sure there are no
cuts, nicks, flat spots or sharp edges. If any of these are present,
re-cut the end with a tube cutter or utility knife. The cut must
be perfectly straight with no angle, otherwise leaking from the
connections may occur.
1. Measure a length of 1/4" tubing (3), to run from the mains
connection fitting (5) to the filter head inlet (2c), and another
length of tubing to run from filter head outlet (2d) to your
tap faucet.
NOTICE: TAP FAUCET NOT SUPPLIED WITH FILTER KIT
Tap faucets are sold separately and can be purchased from a distributor of
Aquaport Water Filter Kits or directly from Aquaport on 1300 764 325.
A selection of tap faucets is available to suit your budget and home décor.
2. Measure 3/4" (19.05mm) from the end of the tubing
provided and mark with a pencil. Fig 5.
3. Push the 1/4" tubing firmly into each fitting (inlet (2c) and
outlet (2d)) on the filter head (2a) until the pencil mark is
8 INSTALLATION AND OPERATING INSTRUCTIONS
Fig 5
3/4"
Correct Cut
19mm
Do Not Remove
Incorrect Cut
Fig 6
pushed next to the collet or until tubing is fully seated. Fig
5. If tubing is removed, re-cut the end, measure, mark and
re-insert.
Note: To remove tubing, push collet against the face of fitting
and remove the hose (with collet still held against fitting face)
Fig 6.
Tubing must be fully inserted/seated to avoid leaks.
Repeat for all other connections.
4. Pull slightly on tubing to ensure tube is secure.
5. Locate a position along the 1/4" tubing (3), between the
mains connection (5) and filter head inlet (2c). Cut tubing
with tube cutter or utility knife and remove sufficient tubing
White Collet
3/4"
Insert 1/4"
Tube to Line
19mm
Push
Push Collet
Collet
Pull
Pull Tubing
Tubing