Aquaport AQP-FKM3 설치 및 운영 지침 매뉴얼 - 페이지 10

{카테고리_이름} Aquaport AQP-FKM3에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-FKM3 17 페이지.

페이지 인쇄

D. Tubing Installation

The Filtration System has been supplied with quick and easy to

install quick connections.

To install tubing, push tubing into connections, and give a slight

pull to ensure tubing is secure:

Note: Check the end of the tubing to make sure there are no

cuts, nicks, flat spots or sharp edges. If any of these are present,

re-cut the end with a tube cutter or utility knife. The cut must

be perfectly straight with no angle, otherwise leaking from the

connections may occur.

1. Measure a length of 1/4" tubing (3), to run from the mains

connection fitting (5) to the filter head inlet (2c), and another

length of tubing to run from filter head outlet (2d) to your

tap faucet.

NOTICE: TAP FAUCET NOT SUPPLIED WITH FILTER KIT

Tap faucets are sold separately and can be purchased from a distributor of

Aquaport Water Filter Kits or directly from Aquaport on 1300 764 325.

A selection of tap faucets is available to suit your budget and home décor.

2. Measure 3/4" (19.05mm) from the end of the tubing

provided and mark with a pencil. Fig 5.

3. Push the 1/4" tubing firmly into each fitting (inlet (2c) and

outlet (2d)) on the filter head (2a) until the pencil mark is

8 INSTALLATION AND OPERATING INSTRUCTIONS

Fig 5

3/4"

Correct Cut

19mm

Do Not Remove

Incorrect Cut

Fig 6

pushed next to the collet or until tubing is fully seated. Fig

5. If tubing is removed, re-cut the end, measure, mark and

re-insert.

Note: To remove tubing, push collet against the face of fitting

and remove the hose (with collet still held against fitting face)

Fig 6.

Tubing must be fully inserted/seated to avoid leaks.

Repeat for all other connections.

4. Pull slightly on tubing to ensure tube is secure.

5. Locate a position along the 1/4" tubing (3), between the

mains connection (5) and filter head inlet (2c). Cut tubing

with tube cutter or utility knife and remove sufficient tubing

White Collet

3/4"

Insert 1/4"

Tube to Line

19mm

Push

Push Collet

Collet

Pull

Pull Tubing

Tubing