Aquasana AQ-4100NSH Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Aquasana AQ-4100NSH. Aquasana AQ-4100NSH 5 halaman. Shower filter
Juga untuk Aquasana AQ-4100NSH: Panduan Pemilik (5 halaman)

Halaman Cetak

USE & CARE/INSTALLATION STEPS

Please read all precautions and instructions carefully before using.

Important Safeguards

• Do not install this filter where the line pressure may exceed 80 psi. The operating

pressure range for this filter is between 30 psi - 80 psi.

• Do not overtighten the chrome inlet collar. This may cause the washer to compress,

resulting in leaking around the connector. If this occurs, unscrew the chrome inlet

collar from pipe, reinstall the washer, and reconnect the shower pipe.

• Do not use with water that is microbiologically unsafe or of unknown water quality

without adequate disinfection before or after the system.

• This system is not intended to be a drinking filter system.

• Only shower heads up to 4.5" in diameter will fit model AQ-4100NSH. This system and

installation must comply with applicable state and local regulations.

Use & Care

• To clean your system, wipe down the exterior with a damp cloth.

• Do not use any strong or abrasive cleaning agent or solvent cleaner.

Scan to view the shower filter

product and installation videos.

Installation Steps

Unpack and Prepare For Installation

1. Remove black plastic caps from Shower Filter Cartridge.

2. Ensure white rubber washer is installed and pressed to the bottom of the

chrome inlet collar. If the washer is out of place, push down to

mitigate leaking.

3. Remove your existing shower head from shower pipe.

Attach Shower Filter Cartridge

1. Wrap Plumber's Tape around threads of shower pipe.

2. Attach chrome swivel collar to shower pipe. Turn

clockwise by hand to tighten. Using pliers, turn chrome

swivel one additional quarter turn. Do not overtighten.

NOTE: If there is pre-existing plumber's tape,

remove old tape before applying new.

Flush Filter

• Turn on COLD water for 2 minutes to

flush the filter. Shower water should run

clear. Then adjust to normal temperature

(mixture of hot and cold water). Turn

water off and on 3 to 4 times or until the

initial surge of water is clear.

Attach Shower Head

For model with shower head

• Attach Massaging Shower Head

to the Shower Filter Cartridge.

Hand tighten.

NOTE: Please see Step 3 to flush filter.

For models with handheld wand

1. Attach Cradle Assembly: Attach Cradle

Assembly to Shower Filter Cartridge.

Hand tighten only.

2. Assemble Hose and Wand: Insert one

washer into hose nut and hand tighten

onto bracket. Insert second washer into

hose nut and screw onto Shower Wand.

3. Place Shower Wand into Cradle

Assembly and adjust to desired

position. Hand tighten swivel nut to

connect Hose to Cradle Assembly.

NOTE: Please see Step 3 to flush filter.

To adjust the water settings (gentle rain,

massage, and combo) on your shower

head, simply twist the shower head ring.

INSTALLATION STEPS