Aquasana AQ-4100NSH Manual do Proprietário - Página 3
Procurar online ou descarregar pdf Manual do Proprietário para Sistemas de filtragem de água Aquasana AQ-4100NSH. Aquasana AQ-4100NSH 5 páginas. Shower filter
Também para Aquasana AQ-4100NSH: Manual do Proprietário (5 páginas)
Imprimir página
2
USE & CARE/INSTALLATION STEPS
2
Please read all precautions and instructions carefully before using.
Important Safeguards
• Do not install this filter where the line pressure may exceed 80 psi. The operating
pressure range for this filter is between 30 psi - 80 psi.
• Do not overtighten the chrome inlet collar. This may cause the washer to compress,
resulting in leaking around the connector. If this occurs, unscrew the chrome inlet
collar from pipe, reinstall the washer, and reconnect the shower pipe.
• Do not use with water that is microbiologically unsafe or of unknown water quality
without adequate disinfection before or after the system.
• This system is not intended to be a drinking filter system.
• Only shower heads up to 4.5" in diameter will fit model AQ-4100NSH. This system and
installation must comply with applicable state and local regulations.
Use & Care
• To clean your system, wipe down the exterior with a damp cloth.
• Do not use any strong or abrasive cleaning agent or solvent cleaner.
Scan to view the shower filter
product and installation videos.
Installation Steps
Unpack and Prepare For Installation
1
1. Remove black plastic caps from Shower Filter Cartridge.
2. Ensure white rubber washer is installed and pressed to the bottom of the
chrome inlet collar. If the washer is out of place, push down to
mitigate leaking.
3. Remove your existing shower head from shower pipe.
Attach Shower Filter Cartridge
2
1. Wrap Plumber's Tape around threads of shower pipe.
2. Attach chrome swivel collar to shower pipe. Turn
clockwise by hand to tighten. Using pliers, turn chrome
swivel one additional quarter turn. Do not overtighten.
NOTE: If there is pre-existing plumber's tape,
remove old tape before applying new.
Flush Filter
3
• Turn on COLD water for 2 minutes to
flush the filter. Shower water should run
clear. Then adjust to normal temperature
(mixture of hot and cold water). Turn
water off and on 3 to 4 times or until the
initial surge of water is clear.
4
Attach Shower Head
For model with shower head
• Attach Massaging Shower Head
to the Shower Filter Cartridge.
Hand tighten.
NOTE: Please see Step 3 to flush filter.
For models with handheld wand
1. Attach Cradle Assembly: Attach Cradle
Assembly to Shower Filter Cartridge.
Hand tighten only.
2. Assemble Hose and Wand: Insert one
washer into hose nut and hand tighten
onto bracket. Insert second washer into
hose nut and screw onto Shower Wand.
3. Place Shower Wand into Cradle
Assembly and adjust to desired
1
position. Hand tighten swivel nut to
connect Hose to Cradle Assembly.
2
NOTE: Please see Step 3 to flush filter.
To adjust the water settings (gentle rain,
massage, and combo) on your shower
head, simply twist the shower head ring.
INSTALLATION STEPS
3
1
3
2