AquaScape PRO-Fit Petunjuk Pemasangan & Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Panduan Pemilik untuk Filter Kolam Renang AquaScape PRO-Fit. AquaScape PRO-Fit 8 halaman. Classic skimmer

Halaman Cetak

STEP 7

Add Rock and Gravel

• You can expect to use several tons

of stone and gravel for your water

feature. Talk to your dealer for

help choosing the quantity and

sizes of stone and gravel.

Rocking in the Pond

• Start from the bottom and set the

largest character boulders first

against the vertical walls; then

stack the smaller boulders on top.

(See fig. 16)

• Be careful when placing any large

boulders so you don't damage the

liner.

• The opening on the front of the

skimmer can be hidden by plac-

ing boulders on either side and

bridging a stone across, creating

a cave effect.

Note: Make sure the boulders do not

block the water flow into the skimmer.

• Cover all remaining flat surfaces

with a couple inches of decora-

tive gravel. This will help lock the

boulders in place, as well as cover

the remaining liner, protecting it

STEP 8

Wash Rocks and Gravel

• Using a garden hose, rinse the

rocks and gravel from the

highest part of the pond down

to the bottom.

• Place an AquascapePro clean-out

pump or the pump purchased

with the pond kit in the lowest

from ultraviolet rays, and giving

bacteria a place to colonize, not to

mention it just looks better.

• This is also a good time to add lilies

to the plant pockets. Remove the lily

from the pot and place it into the

lily pocket. Top-dress the lily with

a layer of gravel to hold the soil into

place. Lilies, if not on hand at this

time, can be added after the pond

is filled. (See fig. 17)

Underwater Lights

• After the boulders are in position,

set your underwater lights in

between your boulders so they are

hidden from view. For the greatest

effect, lights should face away

from the main viewing area.

(See fig. 18)

• See lighting system instructions

for placement, positioning, and

installation of underwater lights.

• 10-watt waterfall lights can be

installed in the stream and water-

fall later in the project.

area of the pond. Use discharge

hose or an extra section of PVC

Flex pipe to pump the muddy

water. This step helps the pond

clear up faster.

Fig. 16 Starting at the bottom, set the largest character boulders first then fill in

with the smaller ones.

Fig. 17 Loose gravel should be placed

around the lily to keep the soil

from being stirred up in the pond

after the water is added.

Fig. 18 Set your underwater lights in

between your boulders so they

are hidden from view.