AquaScape PRO-Fit 설치 지침 및 사용 설명서 - 페이지 6
{카테고리_이름} AquaScape PRO-Fit에 대한 설치 지침 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape PRO-Fit 8 페이지. Classic skimmer
페이지 인쇄STEP 7
Add Rock and Gravel
• You can expect to use several tons
of stone and gravel for your water
feature. Talk to your dealer for
help choosing the quantity and
sizes of stone and gravel.
Rocking in the Pond
• Start from the bottom and set the
largest character boulders first
against the vertical walls; then
stack the smaller boulders on top.
(See fig. 16)
• Be careful when placing any large
boulders so you don't damage the
liner.
• The opening on the front of the
skimmer can be hidden by plac-
ing boulders on either side and
bridging a stone across, creating
a cave effect.
Note: Make sure the boulders do not
block the water flow into the skimmer.
• Cover all remaining flat surfaces
with a couple inches of decora-
tive gravel. This will help lock the
boulders in place, as well as cover
the remaining liner, protecting it
STEP 8
Wash Rocks and Gravel
• Using a garden hose, rinse the
rocks and gravel from the
highest part of the pond down
to the bottom.
• Place an AquascapePro clean-out
pump or the pump purchased
with the pond kit in the lowest
6
from ultraviolet rays, and giving
bacteria a place to colonize, not to
mention it just looks better.
• This is also a good time to add lilies
to the plant pockets. Remove the lily
from the pot and place it into the
lily pocket. Top-dress the lily with
a layer of gravel to hold the soil into
place. Lilies, if not on hand at this
time, can be added after the pond
is filled. (See fig. 17)
Underwater Lights
• After the boulders are in position,
set your underwater lights in
between your boulders so they are
hidden from view. For the greatest
effect, lights should face away
from the main viewing area.
(See fig. 18)
• See lighting system instructions
for placement, positioning, and
installation of underwater lights.
• 10-watt waterfall lights can be
installed in the stream and water-
fall later in the project.
area of the pond. Use discharge
hose or an extra section of PVC
Flex pipe to pump the muddy
water. This step helps the pond
clear up faster.
Fig. 16 Starting at the bottom, set the largest character boulders first then fill in
with the smaller ones.
Fig. 17 Loose gravel should be placed
around the lily to keep the soil
from being stirred up in the pond
after the water is added.
Fig. 18 Set your underwater lights in
between your boulders so they
are hidden from view.