HP 1920 Gigabit Ethernet Switch Series Panduan Memulai - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Beralih HP 1920 Gigabit Ethernet Switch Series. HP 1920 Gigabit Ethernet Switch Series 33 halaman. Hp compaq presario,presario 1900: quick setup
Juga untuk HP 1920 Gigabit Ethernet Switch Series: Pengaturan Cepat (2 halaman), Panduan Memulai (10 halaman)
Halaman Cetak
Connection procedure
CAUTION:
The serial ports on PCs do not support hot swapping. To connect a PC to an operating switch, first connect
the PC end. To disconnect a PC from an operating switch, first disconnect the switch end.
To connect a terminal (for example, a PC) to the switch:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Connect the DB-9 female connector of the console cable to the serial port of the PC.
3.
Connect the RJ-45 connector to the console port of the switch.
Identify the mark on the console port and make sure you are connecting to the correct port.
Setting terminal parameters
Start a terminal application such as HyperTerminal on the computer.Configure the utility with the
following parameters:
Bits per second—38,400
•
Data bits—8
•
•
Parity—None
Stop bits—1
•
Flow control—None
•
Emulation—VT100
•
Powering on the switch
Verification before power-on
Before powering on the switch, verify the following items:
•
The power cord is correctly connected.
The input power voltage meets the requirement of the switch.
•
The console cable is correctly connected.
•
The terminal (for example, a PC) has started, and its configuration parameters have been correctly
•
set.
Powering on the switch
Power on the switch (for example, an HP 1920-24G switch), and the following information is displayed:
Starting......
****************************************************************************
*
*
*
****************************************************************************
HP 1920-24G Switch JG924A BootWare, Version 1.09
14
*
*
*