HP 1920 Gigabit Ethernet Switch Series Руководство по началу работы - Страница 18
Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель HP 1920 Gigabit Ethernet Switch Series. HP 1920 Gigabit Ethernet Switch Series 33 страницы. Hp compaq presario,presario 1900: quick setup
Также для HP 1920 Gigabit Ethernet Switch Series: Быстрая настройка (2 страниц), Руководство по началу работы (10 страниц)
Печатать страницу
Connection procedure
CAUTION:
The serial ports on PCs do not support hot swapping. To connect a PC to an operating switch, first connect
the PC end. To disconnect a PC from an operating switch, first disconnect the switch end.
To connect a terminal (for example, a PC) to the switch:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Connect the DB-9 female connector of the console cable to the serial port of the PC.
3.
Connect the RJ-45 connector to the console port of the switch.
Identify the mark on the console port and make sure you are connecting to the correct port.
Setting terminal parameters
Start a terminal application such as HyperTerminal on the computer.Configure the utility with the
following parameters:
Bits per second—38,400
•
Data bits—8
•
•
Parity—None
Stop bits—1
•
Flow control—None
•
Emulation—VT100
•
Powering on the switch
Verification before power-on
Before powering on the switch, verify the following items:
•
The power cord is correctly connected.
The input power voltage meets the requirement of the switch.
•
The console cable is correctly connected.
•
The terminal (for example, a PC) has started, and its configuration parameters have been correctly
•
set.
Powering on the switch
Power on the switch (for example, an HP 1920-24G switch), and the following information is displayed:
Starting......
****************************************************************************
*
*
*
****************************************************************************
HP 1920-24G Switch JG924A BootWare, Version 1.09
14
*
*
*