HP ProCurve 1600M Suplemen Manual - Halaman 14

Jelajahi secara online atau unduh pdf Suplemen Manual untuk Beralih HP ProCurve 1600M. HP ProCurve 1600M 28 halaman. Redundant power supply
Juga untuk HP ProCurve 1600M: Lembar Spesifikasi (12 halaman), Baca Saya Terlebih Dahulu (8 halaman), Panduan Peninjau (27 halaman), Panduan Tambahan (2 halaman), Panduan Tambahan (2 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (36 halaman), Panduan Instalasi (28 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (8 halaman), Baca Saya Terlebih Dahulu (16 halaman), Instalasi dan Penghapusan (2 halaman), Panduan Instalasi (12 halaman), Panduan Perencanaan dan Pelaksanaan (40 halaman), Petunjuk Pembongkaran Akhir Masa Pakai Produk (2 halaman), Panduan Instalasi (46 halaman), Panduan Diagnostik (2 halaman), Petunjuk Pembongkaran (2 halaman)

Configuring VRRP

Enter the Hello interval or leave the field as is to use the default. The software fills in the default after you

select Add. In this example, leave the field unchanged.

Select the mode (Owner or Backup). Select Backup in this example.

Select Enable to activate the VRRP entry after you select Add.

Enter the backup priority or leave the value unchanged. In this example, enter 100.

NOTE: This is the default for Backups. You also can leave the field unchanged and the software will auto-

matically assign 100 as the priority when you select Add.

Enter the Dead interval or leave the field unchanged to use the default value.

10. Enable preempt mode if desired. In this example, leave preempt mode disabled.

11. Enter the interface's IP address in the IP Address List field. In this example, enter 192.53.5.1. By entering

the same IP address as the one associated with this VRID on the owner, you configure the Backup to back up

the address, but you are not duplicating the address.

NOTE: When you configure a Backup router, the router interface on which you are configuring the VRID

must have a real IP address that is in the same sub-net as the address associated with the VRID by the

owner. However, the address cannot be the same.

12. Enter the virtual interface if applicable. (In this example, the VRRP interface is not defined on a virtual

interface.)

13. Select the track port. In this example, select 3/2.

14. Select Add to add the entry.

Figure 4

Configuration panel for Backup