HP ProCurve 1600M Suplemen Manual - Halaman 15

Jelajahi secara online atau unduh pdf Suplemen Manual untuk Beralih HP ProCurve 1600M. HP ProCurve 1600M 28 halaman. Redundant power supply
Juga untuk HP ProCurve 1600M: Lembar Spesifikasi (12 halaman), Baca Saya Terlebih Dahulu (8 halaman), Panduan Peninjau (27 halaman), Panduan Tambahan (2 halaman), Panduan Tambahan (2 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (36 halaman), Panduan Instalasi (28 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (8 halaman), Baca Saya Terlebih Dahulu (16 halaman), Instalasi dan Penghapusan (2 halaman), Panduan Instalasi (12 halaman), Panduan Perencanaan dan Pelaksanaan (40 halaman), Petunjuk Pembongkaran Akhir Masa Pakai Produk (2 halaman), Panduan Instalasi (46 halaman), Panduan Diagnostik (2 halaman), Petunjuk Pembongkaran (2 halaman)

Halaman Cetak

Modifying VRRP Parameters

You can modify the following VRRP parameters on an individual VRID basis:

•

Authentication type (if the interfaces on which you configure the VRID use authentication)

•

Router type (owner or Backup)

NOTE: Change the router type only if you have moved the real IP address from one router to another or you

accidentally configured the IP address owner as a Backup.

•

Backup priority

•

Suppression of RIP advertisements on Backup routes for the backed up interface

•

Hello interval

•

Dead interval

•

Track port

•

Track priority

•

Backup preempt mode

USING THE WEB MANAGEMENT INTERFACE

You can set some of these parameters using the VRRP configuration panel of the Web management interface,

shown in "Configuring a Virtual Router" on page 11. For information about the fields, see the parameter

descriptions in the following sections. To access this panel, select VRRP from the System configuration sheet,

then click Modify next to the VRRP entry you want to edit.

Authentication Type

If the interfaces on which you configure the VRID use authentication, the VRRP packets on those interfaces also

must use the same authentication. HP's implementation of VRRP supports the following authentication types:

•

No authentication – The interfaces do not use authentication. This is the VRRP default.

•

Simple – The interfaces use a simple text-string as a password in packets sent on the interface. If the

interfaces use simple password authentication, the VRID configured on the interfaces must use the same

authentication type and the same password.

USING THE CLI

To configure the VRID interface on Router1 for simple-password authentication using the password "ourpword",

enter the following commands:

Configuring Router 1

Router1(config)# inter e 1/6

Router1(config-if-1/6)# ip vrrp auth-type simple-text-auth ourpword

Configuring Router 2

Router2(config)# inter e 1/5

Router2(config-if-1/5)# ip vrrp auth-type simple-text-auth ourpword

syntax: ip vrrp auth-type <no-auth|simple-text-auth> <auth data>

Configuring VRRP